I am very new to these devices and trying to find my way around. I am trying to use a USB-6343 to control some relays on a test bench, I have looked at all the examples for creating a digital output and here is where I get stuck:
Configure the Task to use a burst export clock, which configures the
' device for Burst Mode Handshaking, setsthe sample clock rate, exports
' the clock on the specified PFILine, and sets the sample mode to
' Continuous.
I can not figure out how to configure the task for burst export clock in NI-DAQmx tasks. what am I missing? I see the settings for sample clock type and clock source and active edge. am I suppose to configure them manually?
is there a simple example for triggering a digital output and producing a continuous signal as long as the trigger is on?
Regards,
Farid